Aquacraft Nitro Hammer Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Vodní zařízení Aquacraft Nitro Hammer. AquaCraft Nitro Hammer User Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 8
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
Warranty
AquaCraft
will warrant this kit for 90 days after the purchase from defects in materials or workmanship. AquaCraft will
either repair or replace, at no charge, the incorrectly made part.
Make sure you save the receipt or invoice you were given when you bought your model! It is your proof of purchase
and we must see it before we can honor the warranty.
To return your Nitro Hammer
for repairs covered under warranty you should send your boat to:
Hobby Services
1610 Interstate Drive
Champaign, Illinois 61822
Attn: Service Department
Phone: (217) 398-0007 9:00 am - 5:00 pm Central Time M-F
E-mail: hobbyser[email protected]
HCAZ3012 for HCAB26**Entire Contents © Copyright 2002
ASSEMBLY AND OPERATION MANUAL
Before Building:
We want the assembly and operation of this boat to be a success so BEFORE removing any parts from the parts bags please
read this manual thoroughly and watch the included video to familiarize yourself with the model. If for any reason you
think this model is not for you, return it to your local dealer immediately. PLEASE NOTE: Your hobby dealer cannot accept
a return on any model after assembly has begun.
Zobrazit stránku 0
1 2 3 4 5 6 7 8

Shrnutí obsahu

Strany 1 - Before Building:

Warranty• AquaCraft™will warrant this kit for 90 days after the purchase from defects in materials or workmanship. AquaCraft willeither repair or repl

Strany 2

INTRODUCTION ...2SAFETY PRECAUTIONS...2H

Strany 3

Do not use too much force when tightening self-tappingscrews into plastic or fiberglass. Over tightening will causethe threads in t

Strany 4 - RUNNING THE ENGINE

❏ 2. Remove the body clip that holds the lid to the radio boxand carefully remove the cover.❏ 3. Carefully uncoil the receiver antenna and rou

Strany 5 - BREAKING IN THE ENGINE

❏ 3. Open the high-speed needle valve 2-1/2 turns out(counterclockwise) from fully closed. The high-speed needle issticking up on the left si

Strany 6

2. Do not over-lean your engine.3. Do not run your engine without a propeller.4. Do not over heat the engine. This goes along with keepingit clean and

Strany 7 - PERFORMANCE TRICKS AND TWEAKS

equipment to get wet, you must do the followingimmediately: Remove the battery pack and radio equipmentfrom the boat. Allow the components to

Strany 8 - ENGINE TROUBLESHOOTING

• For “drag racing” place the buoys similar to the above sketch.•For “oval racing” place the buoys similar to the abovesketch. NOTE: The above

Komentáře k této Příručce

Žádné komentáře